1. <track id="exrtt"></track><acronym id="exrtt"><label id="exrtt"><listing id="exrtt"></listing></label></acronym>
      <pre id="exrtt"></pre>
      1. SOLUTIONS

        Glass Regenerator

        Glass Regenerator

        Details

        No content

        Recommendation

        ●Regenerator Arch: Under high temperature glass material dust, fuel impurities and alkaline steam high temperature chemical attacks, arch structure experiences suffer enormous high temperature load deformation. Refractories requirement here should have good endurance to erosions and resistance to high temperature creep properties. Traditionally high-quality silica bricks are used, but silica bricks endure to alkaline steam erosion weakly, which sometimes would lead to regenerator arch rapidly damaged. MRL recommends GMB-98A, and fused AZS bricks can also be used.

        ●Top Lattice Structure: The arch of 2-4 layers are easily eroded by glass material dust, alkaline steam and crude oil vanadium oxide and SO2 gas etc. Under high temperature chemical attacks, they need to have good heat conductivity. MRL recommends GMB-97, GMB-98, GMZ-12 products. Fused AZS can also be used.

        ●Upper Lattice Structure: Glass material dust, alkaline steam and toxic gases in smoke would have serious erosion to lattice structure, requirements of endurance to high temperature and high conductivity. MRL recommends GMB-96, GMB-97 or GMB-98, products.

        ●Middle Lattice Structure: According to exhaust air decreasing temperature, the condensation of sulfides and alkaline steam here heading to complex process of erosion reaction and under function of frequent change of temperature, hazardous substances frequent evaporating and condensing would result in volume changes leading to refractories loosening. Therefore, refractories are seriously damaged, becoming one weakest sector of lattice structure. MRL recommends GMK and GMZ products.

        ●Bottom Lattice Structure: The temperature here is lower than 800℃, under higher load and temperature fluctuations, sometimes with sulfuric salt erosion. The low porosity clay brick or high alumina bricks would satisfy requirement here. MRL recommends GMK or GMS products.

        ● Regenerator Walls: Their application conditions should be coordinated with lattice structure. From top to bottom of the walls, MRL recommends GMZ, GMB, GMK and GDN products.

        亚洲福利视频,亚洲成人网站在线观看,国产一级一厂片内射视频播放蘑菇,AV中文在线
        1. <track id="exrtt"></track><acronym id="exrtt"><label id="exrtt"><listing id="exrtt"></listing></label></acronym>
          <pre id="exrtt"></pre>